Impulse .: Novation Answerbase

Does the Impulse have polyphonic aftertouch?
No. The Impulse, along with the other MIDI controllers in the Novation range, features channel aftertouch only.
2013-03-13 Views: 179

What to do if a Impulse firmware update fails
Automap performs a check to see if the firmware on your Impulse is up to date. If new firmware is available Automap will automatically prompt you to update the Impulse. On rare occasions the update...
2012-06-25 Views: 3825

How do I reset the Impulse to factory settings?
Please follow the procedure below to perform a factory reset on the Impulse. 1) Hold down the 'shift', '+' and '-' buttons then connect the USB cable to the Impulse. 2) You will now be in the...
2012-04-19 Views: 4431

Why isn't Middle 'C' in the centre of the Impulse keyboard by default?
Middle 'C' is usually C3 which is defined as MIDI note 60. This is sometimes debated. For example some MIDI devices sometimes have C4 as MIDI note 60. Novation define middle 'C' as C3 which...
2012-04-19 Views: 1276

What type of sustain pedal should I use with the Impulse?
Sustain pedals are usually wired in one of two ways. Some sustain pedals have a switch which is used to change polarity. The Impulse automatically detects the polarity of a connected sustain...
2012-04-19 Views: 2177

How do I control the transport in Garageband with my Impulse
It is possible to use a 3rd party bit of software, GarageRemote (available to download here), to allow MIDI control of the transport in GarageBand. On the Impulse select the Setup button and...
2012-01-25 Views: 3125

How do I make and save adjustments to the hardware controls on my Impulse?
To make adjustments to hardware controls on the Impulse, press the 'Controls' button and move any control on the unit. Now you can freely change CC, Channel number, Min and Max values and Ports...
2011-10-27 Views: 2835

Is there a Pro version of Automap 4?
No, there is only one version of Automap 4 which includes all implemented features. All future Automap 4 updates will be free of charge.
2011-09-01 Views: 4995

Is the Impulse a Midi interface?
Yes, the Impulse controllers come with MIDI IN and MIDI OUT standard 5-pin din connectors on the rear panel of the unit.
2011-09-01 Views: 3923

Are the Impulse encoders touch sensitive?
No, the encoders are not touch sensitive, however the Impulse does have a Learn function which is easily put into practice by clicking a parameter in your software then moving an encoder.
2011-09-01 Views: 3668

Does Impulse work with Automap?
Yes, Impulse works with Automap 4 or above. The latest version of Automap can be downloaded from the Novation website.
2011-09-01 Views: 4511

Impulse

Articles